一种新型可调谐锁模光纤激光器

利用法布里-珀罗腔的激光二极管作为调制器件，实现环形腔光纤激光器的主动锁模。并利用法布里-珀罗腔的激光二极管的多纵模特性，把激光二极管当作一梳状滤波器，通过偏振控制器来调整入射到激光二极管内光的偏振态，同时均衡腔内增益，得到波长大范围可调谐的锁模激光，其脉冲宽度约为48ps，脉冲重复速率2GHz。     

基于分步式压印光刻的激光干涉仪纳米级测量及误差研究

针对在未做隔离保护处理的环境中，基于Michelson干涉原理的激光干涉仪测量系统存在严重的干扰误差，不适合分步式压印光刻纳米级对准测量的要求.采用Edlen公式的分析及计算，不仅在理论上揭示出环境温度、湿度、气压等变化对激光干涉仪测量准确度的影响，而且证明影响测量准确度的最大干扰源是空气流动的结果.通过气流隔离措施和系统测量反馈校正控制器，能够实时补偿激光干涉仪两路信号的相差.最终，测量漂移误差在10 min内由13 nm降低到5 nm以内，满足压印光刻在100 mm行程中达到20 nm定位准确度要求.     

Single-mode rib polymer waveguides and electro-optic polymer waveguide switches

Mode-matching and effective index methods are used to analyze single-mode operation of optical rib polymer waveguides. Their single-mode waveguiding conditions are determined. Single-mode rib waveguides fabricated from guest–host polyetherketone are presented. The estimated propagation loss of straight rib-waveguides is 0.7 dB/cm at 1.55 μm. Furthermore, by using the mode field-transfer matrix method, 2×2 and 4×4 polymer Mach–Zehnder interference switch operating at 1.55 μm wavelength has been designed based on optical multi-mode interference.     

Deposition of Hydrogen-Free Silicon Nitride Thin Films by Microwave ECR plasma Enhanced Magnetron Sputtering at Room Temperature

Hydrogen-free silicon nitride （SiNx） films were deposited at room temperature by microwave electron cyclotron resonance （MW-ECR） plasma enhanced unbalance magnetron sputtering system. Both Fourier-transform infrared spectroscopy and x-ray photoelectron spectroscopy are used to study the bonding type and the change of bonding structures of the silicon nitride films. The results indicate that the chemical structure and composition of SiNx films deposited by this technique depend strongly on the N2 flow rates, the stoichiometric SiNx film, which has the highest hardness of 22.9 GPa, could be obtained at lower N2 flow rate of 4 sccm.     

全光纤脉冲压缩器的理论及实验研究

对色散位移光纤＋普通单模光纤构成的全光纤脉冲压缩器进行了理论分析，分析了压 缩效果与光纤参数及输入脉冲参数的关系；对不同中心波长和脉宽的主动锁模光纤激光器的 输出脉冲进行了压缩实验，均得到了近变换限Sech的压缩脉冲，实验结果与理论分析一致. 关键词： 全光纤脉冲压缩器 压缩因子 基座能量 主动谐波锁模光纤 激光器     

用PM3量化参数预测多氯代二苯并呋喃的logKow

从现有的PCDFs分子的正辛醇 /水分配系数 (logKow)实验数据出发 ,建立定量结构 性质关系方程(QSPR) .采用G98W程序包中的PM3方法对 13 5个多氯代二苯并呋喃 (PCDFs)分子和二苯并呋喃进行了优化计算 ,作业命令为 #pPM3optfreqscf(conver =9) ,以计算所得的分子轨道能量、碳原子电荷作为PCDFs分子结构描述符 ,运用多元线性回归技术建立了PCDFs的logKow与分子结构描述符的四元方程 ,最优相关系数为 0 .95 0 7,标准偏差为 0 .173 7,经检验该模型的稳健性好 ,并对未有实验数据的 85个PCDFs的logKow进行预测     

Yellow‐light‐emitting cyano‐substituted poly[(1,3‐phenylene vinylene)‐alt‐(1,4‐phenylene vinylene)] derivative: Its synthesis and optical properties

A soluble cyano‐substituted poly[(1,3‐phenylene vinylene)‐alt‐(1,4‐phenylene vinylene)] derivative ( 9 ) was synthesized and characterized. Comparison between 9 and its model compound ( 10 ) showed that the chromophore in 9 remained to be well defined as a result of a π‐conjugation interruption at adjacent m‐phenylene units. The attachment of a cyano substituent only at the β position of the vinylene allowed the maximum electronic impact of the cyano group on the optical properties of the poly(p‐phenylene vinylene) material. At a low temperature (?108 or ?198 °C), the vibronic structures of 9 and 10 were partially resolved. The absorption and emission spectra of a film of 9 were less temperature‐dependent than those of a film of 10 , indicating that the former had a lower tendency to aggregate. A light‐emitting diode (LED) based on 9 emitted yellow light (λ_max ≈ 578 nm) with an external quantum efficiency of 0.03%. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 3149–3158, 2003     

电致发光色纯性增强的硅基有机微腔

报道了硅基有机微腔的电致发光（EL）.该微腔由上半透明金属膜、中心有源多层膜和多孔硅分布Bragg反射镜（PS DBR）组成.半透明金属膜由Ag（２０nm）构成，充当发光器件的负电极和微腔的上反射镜.有源多层膜由Al (1 nm) / LiF(05 nm) /Alq3/Alq3:DCJTB/NPB/CuPc/ITO/SiO2组成，其中的Al/LiF为电子注入层，ITO为正电极，SiO2为使正、负电极电隔离的介质层.该PS DBR是采用设备简单、成本低廉且非常省时的电化学腐蚀法用单晶Si来制备的；该PS 关键词： 电化学腐蚀 电致发光 窄峰发射 硅基有机微腔     

CNx纳米管的制备、结构观察及低场致电子发射性能研究

采用高温热解法，以乙二胺为前驱液，在沉积有铁催化剂的p型硅（111）基底上制备出了定向生长的CNx纳米管.利用扫描电子显微镜、高分辨率透射电子显微镜和拉曼光谱对CNx纳米管进行了形貌观察和表征.CNx纳米管的高度在20?μm左右，直径在50—100nm之间，具有明显的“竹节状”结构，结晶有序度较差.对CNx纳米管薄膜进行低场致发射性能测试：外加电场为1.4V/μm，观察到20?μA /cm2发射电流，外电场升至2.54V/μm时发射电流达到1.280mA/cm2，在较高外电场下，没有发现电流“饱和”.这比 关键词： CNx纳米管 高温热解 “竹节状”结构 场致发射     

Sensitivity-enhanced IPAP experiments for measuring one-bond C–C and C–H residual dipolar couplings in proteins

Sensitivity-enhanced 2D IPAP experiments using the accordion principle for measuring one-bond 13C'-13Calpha and 1Halpha-13Calpha dipolar couplings in proteins are presented. The resolution of the resulting spectra is identical to that of the decoupled HSQC spectra and the sensitivity of the corresponding 1D acquisitions are only slightly lower than those obtained with 3D HNCO and 3D HN(COCA)HA pulse sequences due to an additional delay 2Delta. For cases of limited resolution in the 2D 15N-1HN HSQC spectrum the current pulse sequences can easily be modified into 3D versions by introducing a poorly digitized third dimension, if so desired. The experiments described here are a valuable addition to the suites available for determination of residual dipolar couplings in biological systems.